How to change the sealing pad for High Speed Disperser?

Replacing the gasket of a high-speed disperser usually requires the following steps:

Stop the disperser: First, stop the disperser completely and make sure the power is cut off to ensure the safety of the operation.

Remove the old gasket: Open the sealing part of the disperser, usually the sealing cap or cavity. To remove the old gasket, a tool such as a wrench or screwdriver can be used to loosen the fasteners and remove the gasket.

Clean the sealing part: Clean the sealing part to ensure that there is no residual old gasket or dirt. It can be cleaned with appropriate detergents and cleaning tools to ensure that the sealing part is dry and clean.

Install a new gasket: Install a new gasket to the sealing section. Make sure the gasket is properly aligned and not twisted or damaged. Depending on the design of the disperser, fasteners may be required to hold the gasket in place.

Adjust the seal: According to the requirements of the disperser, it may be necessary to adjust the position or pressure of the gasket. Please refer to the instruction manual of the disperser or the instructions provided by the manufacturer to adjust accordingly.

Testing and Inspection: After installing the new gasket, restart the disperser and perform a test run. Make sure the sealing section is free of leaks and seals well. Check for abnormal sounds, vibrations or other problems.

Nanfanchao Tip: If you are not clear about the specific model or the details of the disperser, it is recommended to refer to the operation manual of the disperser or contact the disperser manufacturer for detailed operation guidance and technical support.