Modern environment JFA-Ⅱ Automatic Film Applicator

1. Purpose:

Since the main factors affecting the coating film are the coating speed and the pressure applied on the Film Applicator, etc., the coatings painted by hand are often inconsistent, especially the differences between different people are even greater, which is why This makes it difficult to compare test results between samples.

The company's automatic Film Applicator is carefully designed to allow the operator to conveniently apply an accurate wet film on different substrates, which greatly improves the reproducibility of the film.

2. Main parameters:

1. Coating base size: 470mm×200mm

2. Coatable length: 230mm

3. Coating speed: 0～8cm/s stepless speed change

4. Total power: 100w

5. Power supply: 220V 50Hz

6. Dimensions: 470mm×370mm×230mm (length×width×height)

7. Weight: about 30kg

3. Introduction to the instrument:

1. JFA-Ⅱ automatic film coating machine adopts stepless variable speed motor to precisely control the coating rate.

2. The Wet Film Applicator is driven by a cross bar, and there is no special requirement for the external dimension of the Wet Film Applicator.

4. Operating Instructions:

1. Connect the power supply.

2. Put the substrate to be coated (such as black and white paper) flat on the coating base, and clamp it with the clamp on the base.

3. Place the horizontal push rod on the fixed rods on both sides of the coating base.

4. Press the "Reset" button to make the horizontal push rod reach the initial position of coating.

5. Place the Wet Film Applicator in front of the horizontal push rod.

6. Adjust the speed control knob to choose the appropriate coating speed.

7. Place an appropriate amount of paint to be coated directly in front of the wet film preparer.

8. Press the "Start" button to start coating.

9. After the coating stops, clean up the remaining paint.

10. Remove the prepared sample for the next operation.

5. Matters needing attention:

1. The coating base should be kept clean, and no debris should stick to it, so as not to affect the flatness of the coating base, thereby affecting the next coating; if the paint is accidentally dripped on the coating base, it should be cleaned in time .

2. Regularly check the oil level of the oil cup. If the oil level is found to be insufficient, add lubricating oil in time to lubricate the guide rail.

3. After each use of the device, it should be covered with a dust cover to prevent dust from falling into the machine and affecting its service life.

4. After each use of the equipment, the waste should be cleaned up in time.