Installation Instructions for HLX Series Spiral Force Gauge Benches

Installation Notes

1. Vertical fixed installation using two Φ6.5 countersunk holes on the bottom plate

2. Use the two M4 screw holes on the side of the bottom plate and the M6 ​​screw holes on the positioning plate to move or fix horizontal installation

3. The installation size of the dynamometer mounting plate is 145×30

4. Install the M6×60 stud bolts, M6 knurled nuts and hooks in the accessory bag to the cross arm of the workbench

5. Remove the 4 pieces of M3×10 screws on the back cover of the push-pull force gauge, and use the 4 pieces of M3×14 screws in the accessory bag,

Install the push-pull force gauge on the bench

Introduction to maintenance

1. Pay attention to keep all parts of the workbench clean

2. When you feel that the movement of the workbench is sluggish and inflexible, please add a little oil to lubricate the joint between the guide rail and the guide sleeve