电池隔膜透气性测试仪是气体透气性测试仪之一,适用于电池隔膜透气性的检测。适用于各种纺织面料的透气性测试,包括工业织物、非织造布等透气材料。那么如何用压差法和恒压法来维护电池隔膜渗透率仪呢?
压差法具有很多优点,其中主要的一个优点是它对于测试气体没有选择性,而且传感器也并非损耗型,不存在使用时间和使用量的限制。因此对于压差法设备来讲,留意操纵细节是进行设备维护的重点。
(1)避免有异物进进测试下腔,由于测试下腔与真空泵是直接相连的,所以假如下腔中存在异物则会被抽进真空泵内,对真空泵造成损坏。
(2)真空泵油应使用厂家提供的真空泵专用油,在使用时真空泵内的油量应控制在规定的范围内,并留意油质的变化。
(3)对于早期的压差法设备,有些真空测压计是含有水银成分的装置,这时需要特别留意水银的存放安全。
等压法设备主要采用氧传感器进行材料的透氧性检测,而采用的氧传感器是损耗型的,其中的有效探测成分会随着测试时间的延长而逐步损耗,而将其暴露在高浓度的氧气或空气中会很快被消耗而无法再继续使用。更换氧传感器本钱昂贵,因此维护等压法设备重要的一点是保护氧传感器隔尽外界气体以延长其使用寿命。
先要确保试样装夹完好,避免泄漏。其次在试验过程中要先对测试系统进行吹扫,直到其中的氧含量降到极低的状态后再进进渗透过程,同时若试样的透氧量较大也需要采取措施防止氧传感器内的氧含量持续偏高以减少氧传感器的损耗。
再次,在试验结束后需要将氧传感器内气体的氧含量降到低,若仪器近期还要做试验,可先用大流量载气对测试腔进行吹扫然后再把载气流速调小并持续吹扫系统以防止外界氧气的渗透;若近期不使用设备只有在确认气流的氧含量足够少时(如系统被高纯氮气吹扫2小时以上),才可封闭氧传感器保护阀然后封闭钢瓶输出阀停止供气。然而由于传感器的损耗直接影响测试数据的正确性,所以等压法设备需要定期标定。
It is also necessary to pay special attention to the fact that the equal pressure method equipment always needs to use a large amount of carrier gas to purge the test system no matter during the test process or after the end of the test, so the test exhaust gas discharge is quite large, so it is necessary to pay attention to the treatment of the exhaust gas. The air guide tube should be used to connect the exhaust gas outlet of the instrument and lead the exhaust gas to the outside. At the same time, attention should be paid to the indoor air circulation to keep the air fresh.
The current equal pressure method equipment generally has the function of controlling the temperature and humidity of the test gas. To control the humidity of the test gas, it is inevitable to add humidity generating substances in the gas path, and the long-term existence of moisture in the gas path is not conducive to equipment maintenance. , so after the humidification test is over, it is necessary to remove the humidity generating substance in the humidity increasing device and blow off the moisture in the system with dry nitrogen.