Nanbei Chao technical engineer tells you: What are often asked when buying a wire rod?

1. Question: Are there 1mm-2mm wire rods? I want to know if there is any?

     Answer: Hello, the maximum size of the conventional wire rod is about 200 microns, and the available Wet Film Applicator is 1mm-2mm. I will send you several products that meet your requirements for you to choose.

2. Question: Do you have any wire rod coaters involved in GB/T26461?

     Answer: Hello, the OSP-10/60 wire Bar Coater is fine.

3. Question: How do you choose the film thickness of your applicator?

     Answer: Hello, users generally choose the model according to the actual thickness of the wet film to be coated.

4. Question: Hello, the general dry film thickness is about 20-30, what is the wet film thickness?

     Answer: Hello, dry film wet film converter tool.nbchao.com/ganmo/ wet film thickness calculator tool.nbchao.com/mohou.

5. Question: Can the product with high viscosity be scraped off with a 200 micron wire rod?

     Answer: Hello, no matter how high the viscosity is scraped with a wire rod, the effect will not be very good. It is recommended to choose a coating machine with a scraper, and the effect will be better.

6. Question: The solid content of the glue is between 50-70%, and the thickness of the coating film needs to be controlled at 20-40um. How to choose the wire rod spiral?

     Answer: Hello, theoretically dry film = wet film * solid content. The selection of the wire rod is generally based on the wet film thickness of the coating film.

7. Question: Is there any 250um wire Bar Coater?

     Answer: Hello, I just checked for you. The thickness of 250μm is basically not available for all brands of wire Bar Coaters. I personally recommend you to use a wet film preparer, which can reach your wet film thickness. What is your coating width?

8. Question: Can the wire rod be scraped for the photosensitive paint experiment coating?

     Answer: Hello, yes.

9. Question: How do you sell your products?

     Answer: Hello, if you are shopping at NBCHAO Mall for the first time, you can refer to our shopping guide nbchao.com/h/1.

10. Question: How do you feel there is rust on the wire rod?

       Answer: Hello, it is normal for the wire rod to appear this way. Because there is a layer of oil attached to the surface of industrial products, sometimes this will happen if it is not cleaned up when leaving the factory, so just wipe it off with thinner. Thank you for your advice!