China

Pushen QTY-32 Bending tester

SE
Anodic oxidation aluminum material; containing 12 stainless steel shaft rods; shaft bending test; in line with GB/T6740, ISO1519 standards.
$425.15/set
PromotionLoading...
Coupon
Model:
Certificate

Pushen QTY-32 Bending testerSPEC

Pushen QTY-32 Bending testerDetails

Pushen QTY-32 Bending testerPacking list

SKU
NB019517
Shaft rod size
2/3/4/5/6/7/8/10/12/16/20/25/32mm
Shaft rod material
stainless steel
Test board specification
120×50mm
Operation mode
manual
Standards
GB/T 6742,ISO 1519
Overall dimensions
170*110*230mm
Shipment weight
7Kg
QTY-32
Bending tester
Anodic oxidation aluminum material; containing 12 stainless steel shaft rods; shaft bending test; in line with GB/T6740, ISO1519 standards.
Pushen QTY-32 Bending tester Picture

QTY-32 Cylindrical Bending Tester

By bending the coated metal substrate at a set radius, the ductility and adhesion of the paint film under the bending stress can be obtained.

The bend tester is a simple and quick method to measure the elasticity of the coating. Just bend the coated test panel on a circular shaft of known diameter, and then check the coating for cracking, peeling or other damage.

Made of anodized aluminum

There are 12 stainless steel shaft rods

Test panels up to 50mm wide can be measured

Shaft diameter: 2, 3, 4, 5, 6, 7, 8, 10, 12, 16, 20, 25, 32 mm

Steps

Applying paint to metal substrates

Carefully apply the film and bake it dry to ensure good reproducibility

During the experiment, bend the test substrate to 180° evenly within 1-2 seconds

Starting with the largest diameter mandrel, test in descending diameters until coating breakage is visible

Structural diagram of Pushen QTY-32 cylindrical bending tester

Pushhen QTY-32 Cylindrical Bending Tester Experimental Diagram

Standards

GB/T 6742-2007 Paints and varnishes bending test - cylindrical shaft

ISO 1519-2011

FAQ
QWhat are the requirements for Sample size?
A Tinplate sheet 120x50x1mm
QWhat material is the QTY-32 cylindrical Bending tester?
A Hello, the instrument is anodic oxidation aluminum, with 12 stainless steel shaft rod.
QHow should the QTY-32 Bending tester be stored and maintained?
A Hello, pay attention to moisture-proof and anti-collision. If you do not use it for a long time, all shaft rods should be coated with anhydrous Vaseline.
QIs there an ISO1519 standard cylindrical Bending tester?
A This PUSHEN cylindrical Bending tester is fine!
QHello, this Bending tester, do you have any requirements for the test board?
A Hello, according to the standard, the substrate should be a steel plate, Film thickness is 0.7-1 mm and meets the requirements of ISO 1514. The substrate should have a suitable size, preferably 200 * 100mm.
Standard