CHINA QFZ film Adhesion tester

QFZ

Film Adhesion Tester

QFZ type paint film adhesion tester is used to measure the adhesion ability of various coating films to the surface of the object to be coated.

Structural principle

The main transmission part of the QFZ paint film adhesion tester is composed of a hand wheel, a sprocket, and a helical helical gear. When the hand wheel is turned, the worktable moves left and right, and the needle is drawing a circle at the same time.

The drawing header part is composed of the following two components.

The double-head square screw is used to adjust the machine head up and down.

The drawing diameter is adjusted by the lower dovetail plate connected with a sliding dovetail and a screw that can drive the hand tracing needle.

3. The workbench is equipped with a movable half nut connected to the lead screw at one end to drive the workbench to move back and forth. There are four nuts and two pressure plates on the workbench for pressing and releasing the test piece.

4. The base part is used to support the workbench and tracing head, etc.

Instructions

1. Prepare samples according to the requirements.

2. Check the steel needle. It is recommended to replace it with a new steel needle at the beginning of use. The distance between the needle tip and the work surface is about 3 mm.

3. Adjust the eccentric position of the needle tip according to the required drawing diameter, and then tighten it with screws.

4. Put the prepared sample with the coating film facing up and install it on the workbench and press it tightly with a pressure plate.

5. Add weights on the weight plate according to the regulations.

6. Lift the movable half nut to move the workbench to the outer end, and then put down the movable half nut.

7. Turn the pressure lever to make the needle tip contact with the membrane surface.

8. Shake the hand wheel, and the steel needle will draw a spiral pattern on the sample plate. According to the pattern, the adhesion of the coating film can be judged as excellent, good, medium, poor, and poor.

Packing list：QFZ type film Adhesion tester × 1, manual × 1

[Note]Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.