Japan OSP S-12 wire brush steel wire length 12mm for Spreader roller, anilox roller cleaning

S-12

Stainless steel brush

The diameter of the steel wire is 0.06mm, the number of rows is 4, there are 62 acupoints, the thickness of the pedestal is 10mm, the width of the pedestal is 17mm, the length of the pedestal is 235mm, and the width of the bristle part is 12mm.

Introduction

Japan OSP wire brush S-12 has a steel wire bristle length of 12mm, a bristle part width of 12mm, and a length of 75mm. The S-12 wire brush is suitable for cleaning laboratory wire rods or production machine anilox rollers. The S-12 wire brush has a wooden base.

main application

The anilox roller wire brush is used to clean the anilox roller, suitable for cleaning the anilox roller of the production machine, cleaning the laboratory coating wire rod, etc. The cleaning effect of the anilox roller wire brush is effective, and it does not damage the instrument

Features

1. The stainless steel brush (anilox roller wire brush) sold on the market at present has the smallest Wire diameter of 0.07mm, and the Wire diameter of this anilox roller wire brush is only 0.06mm! Because it is fine, it can be cleaned more effectively.

2. Because the diameter of the steel wire is only 0.06mm, the bristles are super soft, which will not damage the roller surface while cleaning.

3. This wire brush is made in Japan. Each one is handmade by artisans with years of experience.

Instructions

   1) After shutting down, first wash off the ink on the surface of the wire Bar Coater with clean water.

   2) Spread the cleaning liquid directly on the surface of the anilox roller evenly, wait for about ten minutes, and then use the anilox roller wire brush to scrub the wire Bar Coater in a circular motion for 3 to 5 minutes, during which the cleaning liquid will produce some foam. After brushing, let the foam stay on the surface of the anilox roller for 3 to 5 minutes.

   3) Finally, rinse off the cleaning solution with clean water. Pay attention to cleaning, do not leave cleaning fluid on the surface of the anilox roller.

   4) If the wire Bar Coater is seriously blocked: Prolong the residence time of the cleaning solution and the brushing time, or repeat the above steps.

Packing list：Wire brush X1

[Note]Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.