Japan OSP M-16 wire brush wire length 16mm without hand grip part

M-16

Stainless steel brush

The diameter of the steel wire is 0.06mm, the number of rows is 6, the thickness of the pedestal is 14mm, the width of the pedestal is 58mm, the length of the pedestal is 128mm, and the width of the bristle part is 50mm.

Introduction

Japanese OSP steel wire cleaning brush M-16 has steel wire bristles with a length of 16mm, a bristle part with a width of 50mm and a length of 120mm, and has 6 rows. M-16 steel wire cleaning brush is suitable for laboratory wire rod or production machine anilox roller cleaning. The base of the M-16 wire brush is made of wood with a thickness of 14mm.

main application

The anilox roller wire brush is used to clean the anilox roller, suitable for cleaning the anilox roller of the production machine, cleaning the laboratory coating wire rod, etc. The cleaning effect of the anilox roller wire brush is effective, and it does not damage the instrument

Features

1. The stainless steel brush (anilox roller wire brush) sold on the market at present has the smallest Wire diameter of 0.07mm, and the Wire diameter of this anilox roller wire brush is only 0.06mm! Because it is fine, it can be cleaned more effectively.

2. Because the diameter of the steel wire is only 0.06mm, the bristles are super soft, which will not damage the roller surface while cleaning.

3. This wire brush is made in Japan. Each one is handmade by artisans with years of experience.

Instructions

   1) After shutting down, first wash off the ink on the surface of the wire Bar Coater with clean water.

   2) Spread the cleaning liquid directly on the surface of the anilox roller evenly, wait for about ten minutes, and then use the anilox roller wire brush to scrub the wire Bar Coater in a circular motion for 3 to 5 minutes, during which the cleaning liquid will produce some foam. After brushing, let the foam stay on the surface of the anilox roller for 3 to 5 minutes.

   3) Finally, rinse off the cleaning solution with clean water. Pay attention to cleaning, do not leave cleaning fluid on the surface of the anilox roller.

   4) If the wire Bar Coater is seriously blocked: Prolong the residence time of the cleaning solution and the brushing time, or repeat the above steps.

Packing list：Wire brush X1

[Note]Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.