AISRY LX-5612 Taber Wear Tester
The speed of the experimental plate is 60,70 rpm or specified, the counter electronically displays 6 digits, and can automatically stop. The outer diameter of the test piece is 100mm, the inner diameter is 8mm, and the Film thickness is 3mm.
Model：
LX-5612
Similar products
AISRY LX-5612 Taber Wear testing machineSPEC
AISRY LX-5612 Taber Wear testing machineDetails
AISRY LX-5612 Taber Wear testing machinePacking list
- SKU
- NB022128
- test piece
- Outer diameter 100mm, Inner diameter 8mm, Film thickness 3mm
- Load
- 250g,500g,1000g
- Counter
- Electronic display 6 digits, automatic stop
- Test disk speed
- 60,70 rpm or as specified
- Machine size
- 320*480*310mm
- Machine Weight
- About 18kg
- Annex
- 1 piece of test piece cutter, 1 piece of wrench, 1 group of grinding wheels, 1 pack of yarn paper
- Coating wheel number
- CS17
- plywood
- CS32 CS33
- cloth
- H18 H22，CS17
- plastic
- CS17, H18, H22 (grinding wheel optional)
- Power
- AC220V 50HZ
LX-5612
Taber Wear testing machine
The speed of the experimental plate is 60,70 rpm or specified, the counter electronically displays 6 digits, and can automatically stop. The outer diameter of the test piece is 100mm, the inner diameter is 8mm, and the Film thickness is 3mm.
Introduction
This machine is suitable for wear resistance test of leather, cloth, paint, paper, floor tile, plywood, glass, natural rubber, etc. The method is to cut the test piece with a standard cutter, use a specified type of grinding wheel, and load a certain weight to wear it. After reaching the specified number of revolutions, take out the test piece, and observe the condition of the test piece after grinding or the difference between the weight of the test piece before the test and the weight after the test. Abrasion index calculation formula: Abrasion loss weight/test revolutions×1000 Optional grinding wheel number: H18
FAQ
QCan rubber runways be inspected?
Does it meet the new national standard GB 36246-2018 wear resistance testing machine?
A
It can be detected and conforms to the new national standard GB 36246-2018.
QWhat is the weight of the abrasion arm?
A
Without weight, it is 250G;
Load: 250g, 500g, 750g, 1000g;
1000G load, just put a 750 weight.
QWhat is the range that can be set for the number of revolutions?
A
Test speed is generally 60 rpm 72 rpm
QThere is a vacuum cleaner interface, is it equipped with a vacuum cleaner?
QAluminum profile surface lame plating plastic powder to do an abrasion resistance testing, mainly to test the wear resistance performance, I think the greater the Hardness, wear resistance is good
A
This one is ok.
QAluminum profile surface lame plating plastic powder, test abrasion resistance, suitable?
A
suitable
Standard