Yongxin GBJ-A fiber standard dissociator
SE
GBJ-A
ChangChunYongXin GBJ-A Fiber standard dissociator SPEC
ChangChunYongXin GBJ-A Fiber standard dissociator Details
ChangChunYongXin GBJ-A Fiber standard dissociator Packing list
- SKU
- NB034355
- Container size
- F152 * 191mm
- Inner baffle spiral
- Width of four inner helix lines × spacing × number of roots: 6.5 × 51 × 4
- Stirring blade
- Φ90 three blades
- Stirring steering
- Clockwise swirl/spin as seen from above
- Stir blade distance from bottom of container
- 25mm
- Impeller rotation frequency
- 48.3±1.65S
- Impeller revolutions
- 2900±100rpm
- Power
- 220V 50Hz
- power
- 200W
- Environment Operating Temperature
- 10~40℃
- Environment Relative Humidity
- 75% RH
use
This separator meets the standard requirements of ISO5263-1979 "Pulp-LABOratory Wet Dissociation", and is a special equipment for dissociation of pulp in the paper industry. It is suitable for wet dissociation pulp: that is, through this dissociation device, the interwoven fibers are mechanically treated in water, so that the original intertwined fibers are separated from each other again, and the original structure and properties of the fibers are kept unchanged as much as possible to ensure Obtain reliable data from experiments, scientifically guide scientific research and production, and effectively use the original pulp.
This machine is suitable for paper mills, pulp mills, scientific research units, quality testing center laboratories, pulp dissociation and extraction of standard pulp samples. It is the preferred equipment for improving and improving product quality.
dissociation condition
| Variety of pulp | Pulp amount g | Soaking time | Dissociation volume mL | Total number of revolutions |
| chemical pulp | twenty four | 4 hours | 2000 | 75000 |
| flash dried pulp | 60 | 4 hours | 2700 | 30000 |
| mechanical pulp | 60 | 4 hours | 2700 | 30000 |
| flash-dried mechanical pulp | 60 | 10min | 2700 | 30000 |
Note: 10,000 rpm should be used for dissociation if the dry matter content of pulp is less than 20% (weight).
structure
This machine is composed of (see attached picture 1) 1 machine base, 2 containers, 3 agitator, 4 main body, 5 control system, 6 buttons and 7 positioner. The control system is on the upper part of the machine base, and the upper part of the main machine can be lifted up to a certain angle so that the agitator can be lifted from the container, and the pulp container can be easily taken out. The control system (see Figure 2) is located at the front of the main body on the control panel. There are: 1. Power switch 2. Stop key 3. Start key 4. Preselection key 5. Actual number of revolutions 6. Preselection number of revolutions.
