RONGHUA HDM-3000C Digital Temperature Control Electric Mantle 3000ml/600W

HDM-3000C

Digital Temperature Control Electric Mantle

Digital display, 3L, power 600W, Voltage~ 220V +/- 10%, maximum operating temperature 380 ℃ (heating element surface temperature), Temperature range environment temperature~ 380 ℃, continuous working time

Introduction

The electric heating mantle is mainly used for heating laboratory liquids in various technical secondary schools, petroleum, chemical, pharmaceutical, environmental protection and other industries. It uses high temperature resistant alkali-free glass fiber as insulating material, and the resistance wire is sealed in the insulating layer, and then Woven into a hemispherical internal heat heater. This product has the advantages of large heating area, fast heating, good heat preservation effect, no open flame, and not easy to damage glassware. This product is a reliable heating equipment for laboratories and fine chemical units.

Features

The digital display intelligent temperature control type (HDM-C type) electric heating jacket is equipped with two sensors for temperature measurement, which are designed at the back of enclosure, and plugged into the "built-in sensor" plug to measure the temperature of the built-in sensor and measure the temperature of the board surface. Unplug the "built-in sensor" plug, replace the "external sensor" plug, put the external sensor into the material to be measured, and measure the temperature of the material.

Series

Precautions

1. Since the surface of the glass fiber is coated with grease, the temperature should be raised slowly when using it for the first time. Turn off the power after seeing white smoke, and turn on the power to heat up after the smoke is scattered. Repeat several times until the power is on and there is no smoke before it can be officially used.

2. No flammable, explosive or corrosive liquid or gas can enter the heating mantle. The relative Operating Environment humidity of the electric heating mantle does not exceed 85%.

3. This product must be grounded, and it must be kept dry and kept away from moisture. If it is wet, you should pay attention to the induction electricity when using it, and don't touch it with your hands. It can restore its good insulation performance after it dries.

Packing list：host X1, certificate X1, manual X1, warranty card X1

[Note]Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.