China

CHINA NBC-1025 Peel strength Tester 90 degree Peel strength Tester

SE
Maximum disbonding load 50kg, Test speed 10~60mm/min, experimental stroke 0~360mm adjustable, using pointer induction mode.
$689.00/set
PromotionLoading...
Coupon
Model：
Contact
Details SPEC Con CAT OI

Factory NBC-1025 Peel strength TesterSPEC

Factory NBC-1025 Peel strength TesterDetails

Factory NBC-1025 Peel strength TesterPacking list

SKU
NB044562
Maximum load
50Kg
Test speed range
10~60mm/min
induction method
pointer sensing
effective travel
0~360mm
Weight
About 40kg
Volume
66x30x72cm
Power
AC220V/50HZ
NBC-1025
Peel strength Tester
Maximum disbonding load 50kg, Test speed 10~60mm/min, experimental stroke 0~360mm adjustable, using pointer induction mode.
CHINA NBC-1025 Peel strength Tester 90 degree Peel strength Tester Picture

use

This machine is specially used to test the adhesion of copper foil circuits on PC boards or the fastness of tin foil, lead foil, tape, etc. to the surface of objects. During the test, the test piece is peeled off at a vertical angle. The actual 90 degree peel strength can be measured. Optional high-precision digital push-pull force meter.

Safety Precautions

1. The testing machine only uses single-phase 220V AC power supply.

2. Do not place flammable objects around the testing machine to avoid fire.

3．The test case must be grounded, otherwise there is a risk of electric shock.

4. The incoming line end of the power supply should be connected to a leakage protection air with a certain amount; switches and contactors can cut off the power supply in case of emergency.

5. Never touch the electromagnet when the machine is working.

6．If you need to move the machine, you must cut off the power supply before moving.


FAQ
QI want to measure copper foil adhesion on a circuit board, what instrument should I use?
A Recommended NBC-1025 Peel strength tester, which specializes in measuring the adhesion of PC plate copper foil, can disbonding the specimen vertically at 90 degrees, and directly get the peel strength data, which meets your needs.
QWhat materials is this disbonding tester suitable for?
A In addition to measuring PC copper foil, it can also measure the fastness of tin foil, lead foil, and tape to the surface of the object. It is often used in factories for mass inspection because of its simple operation and accurate results.
QWhat common application scenarios is this disbonding tester suitable for?
A Widely used in PC board copper foil circuit, tin foil, lead foil and tape and other materials adhesion fastness test, through the vertical disbonding method to simulate the actual use conditions, to ensure that the material bonding mass meets the standard.
QWhat equipment is required for tape tack testing?
A You can use the NBC-1025 Peel strength tester, which is suitable for adhesive fastness testing of materials such as tape and tin foil. The speed can be adjusted by 10-60mm/min, which can simulate the actual disbonding process and ensure reliable results.
QIs the tape tack test suitable for this machine?
A NBC-1025 can not only measure copper foil adhesion, but also can be used for adhesive fastness testing of tape, tin foil, lead foil and other materials. The adjustable speed of 10~ 60mm/min can adapt to the disbonding test requirements of different materials.
Standard
Filter Brand Store Contact