APPLENT AT515 Precision DC Resistance Tester 0.01μΩ~ 1GΩ Range Shunt Resistance
AT515
Applent AT515 DC resistance TesterSPEC
Applent AT515 DC resistance TesterDetails
Applent AT515 DC resistance TesterPacking list
- SKU
- NB005823
- Measurement parameter
- DC resistance
- Basic Precision
- 0.01%
- Measurement range
- 0.01μΩ~1GΩ
- signal source
- Current range: 1μA~ 1A
- range
- 11 range automatic and manual
- Measurement speed
- 167 times/second, 30 times/second, 10 times/second, 2 times/second
- Show results
- Direct reading, delta ABS, delta% and sorting results
- Maximum reading
- 1200000
- correction
- Short circuit clearing in full scale
- comparator
- Built-in 14-speed comparator, display and output BIN1~ BIN10, HIGH, IN, LOW sounds
- trigger method
- Internal trigger, manual trigger, external trigger and remote trigger
- interface
- RS232C interface Handler interface (PLC interface)
- temperature compensation
- Precision: 0.2 ℃ Temperature range: 0~80 ℃
- test side
- 4-Terminal Shielding (including 2 detection terminals and 2 drive terminals) and outer Shielding ground terminals
- power requirements
- Voltage: 198VAC~ 240VAC Frequency: 50Hz Power: Maximum 15VA
- size
- Outer Dimensions (mm): 264 (W) x107 (H) x350 (D) Inner Dimensions: 216 (W) x88 (H) x323 (D)
- Weight
- 4kg
AT515 Precision DC Resistance TesterBrief introduction
The AT515 is a precision DC resistance Tester for testing ultra-low or low shunt resistance, a miniature benchtop instrument controlled by a high-performance ARM microprocessor. The instrument has an accuracy of 0.01% and a resolution of 0.01μΩ, and a measurement range of 0.01μΩ~1GΩ. Superior repetitive measurement accuracy; The resistance value is displayed in 7 digits with 1,200,000 readings and a maximum sampling speed of 6ms. The instrument has a built-in temperature compensation interface to compensate for errors caused by temperature.
The instrument has a built-in 14-step comparator output that can be set to 10 qualifying levels, and all comparator results can be output via the Handler interface.
The instrument is equipped with RS-232 interface as standard, and uses SCPI (Standard Command for Programmable Instrument) to communicate with computers, PLCs or WINCE devices for effective remote control and data acquisition functions.
Performance characteristics
●Temperature compensation function.
●High current test function (open circuit Voltage< 20mV).
●Compatible with SCPI instruction set.
●Excellent repetitive measurement accuracy
● Keypad lock function.
● Data retention function.
●Comparator function and data output function
Display diagram
Application
●Measure a variety of high, medium and low value resistors
●Various switch contact resistors
●Enameled wire resistance
●Connector contact resistance
● Relay wire pack and contact resistor
●Winding resistors for transformers, inductors, motors, and deflection coils
●Solder joint contact resistance
●Wire resistance
●Metal riveting resistors for cars, ships, and airplanes
● Printed plate lines and porosity resistors
●Characterize the low-resistance characteristics of electromechanical components
●Metal flaw detection, etc
AMBE DC Resistance Tester Selection Table
