PUSHEN QTY-32 Bending Tester coating resilience 12 stainless steel shafts

QTY-32

Bending Tester

Using 12 stainless steel shaft rods with a diameter of 2-32mm, the 50mm wide test plate can be tested, and the anodic oxidation aluminum material ensures durability. Fast detection of coating cracking and adhesion performance through 180 ° bending.

QTY-32 Cylindrical Flexure Tester

By bending the coated metal substrate at a set radius, the ductility and adhesion index of the paint film under bending stress can be obtained.

The flexometer is a simple and fast way to determine the elasticity of a coating by simply bending the coating plate on a circular shaft of known diameter.

Then check the layer for cracking, peeling, or other damage.

Made of anodized aluminum

There are 12 stainless steel shaft rods

Panels up to 50 mm wide can be measured

Bar diameter: 2, 3, 4, 5, 6, 7, 8, 10, 12, 16, 20, 25, 32 mm

Procedure

The paint is applied to the metal substrate

Carefully coat the film and bake it dry to ensure good reproducibility

During the experiment, bend the test substrate to 180° evenly and forcefully within 1-2 seconds

Starting with the largest diameter shaft rod, the decreasing diameter is tested until the coating breakage is visible

Meets standards

GB/T 6742-2007 Bending test for basecoat and varnish - Cylindrical shaft

ISO 1519-2011

Technical Specifications:

Shipping list

One cylindrical bendometer

12 stainless steel shaft rods

A copy of the instruction manual

Packing list：Bending tester X1, shaft rod X12, instruction manual X1

[Note]Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.