Japan OSP-05/60 Proofing rod WFT 5μm length 60mm
SEFormed, wet film thickness 5μm, diameter 10mm, Total length 60mm, application width 60mm, material 304 stainless steel.
$115.00/piece
PromotionLoading...
Coupon
Model：
OSP-05/60
Similar products
-
US RDS 2 #3/8 "Mayer Rods 4.6μm molding coating bar$ 161.00SE -
UK RK KHC.11.1 long coating rod WFT 6μm yellow rubber head No. 1 rod$ 167.00SE -
UK RK KHC.10.1 short coating rod WFT 6μm yellow rubber head No. 1 rod$ 152.00SE -
RDS #2 Mayer Rods WFT 4.6μm Length 400mm$ 155.00SE -
Japan OSP-05/250 thread coating bar WFT 5μm length 250mm$ 152.00SE
OSP OSP-05/60 coating rodSPEC
OSP OSP-05/60 coating rodDetails
OSP OSP-05/60 coating rodPacking list
- SKU
- NB000060
- Production process
- Formed
- WFT
- 5μm
- diameter
- 10mm
- Total length
- 60mm
- Application width
- 60mm
- Grip width
- 0
- material
- 304 stainless steel
OSP-05/60
coating rod
Formed, wet film thickness 5μm, diameter 10mm, Total length 60mm, application width 60mm, material 304 stainless steel.
The traditional coating rod is a wire-wound type coating rod. At that time, due to the problem of broken wire during use, or the problem that it was difficult to clean after being blocked by impurities. The Japanese OSP coating rod breaks the tradition and develops a new extrusion coating rod. It uses a special cold extrusion process to process a steel rod to form a coating rod with continuous grooves. Control wet film thickness, fine workmanship. The thickness of OSP-05 coating rod coating film is 5μm.
Optional
 |
|
 |  |
Note: Click on the accessory picture to view Details.
FAQ
QDoes this need to be matched with a handle to scrape?
A
In theory, it is not necessary to match, but considering that it is only 6cm long and difficult to control manually, it is recommended to match the handle.
QCan this coating rod be prepative of multi-layer ultra-thin film?
A
The wire rod can be prepared for 1.5 micron ultra-thin film. Everyone must know it, but another advantage of it is multi-layer film, which is much better than I-shaped film applicator. But multi-layer film tests the flatness of the previous layers of film drying. Generally, the film thickness (such as less than 10 microns/layer) is too thin to control. The wire rod with Film Applicator is a very good solution, eliminating the problem of uneven pressure and speed of hand scraping.
QDoes OSP Mayer Rods meet the ASTMD823 standard?
A
The Mayer Rods of the OSP-05/60 can be referred to
Knowledge
- 1Bar Spreader Technology: Principles, Applications and Advantages over Miscellaneous coating methods
Standard
- 1GB/T 1727-2021《General methods for preparation of coating films》
- 2HG/T 5370-2018《Waterborne coatings for bicycles》
- 3HG/T 3951-2007《Water based colorants for architectural coatings》
- 4GB/T 13217.1-2020《Test method for colour and tinctorial strength of ink》
- 5GB/T 26461-2011《Gravure ink for paper》
- 6ASTM D823-2018《Paints, varnishes and related products of uniform thickness on the test board》